Add/Edit A Qos Shaper; The Qos Policer Setup Screen - ZyXEL Communications VMG3925-B10A User Manual

10.6.1 Add/Edit a QoS Shaper

Click Add New Shaper in the Shaper Setup screen or the Edit icon next to a shaper to show the
following screen.
Figure 73 Shaper Setup: Add/Edit
The following table describes the labels in this screen.
Table 51 Shaper Setup: Add/Edit
LABEL
Active
Interface
Rate Limit
OK
Cancel

10.7 The QoS Policer Setup Screen

Use this screen to view QoS policers that allow you to limit the transmission rate of incoming traffic
and apply actions, such as drop, pass, or modify the DSCP value for matched traffic. Click Network
Setting > QoS > Policer Setup. The screen appears as shown.
Figure 74 Network Setting > QoS > Policer Setup
The following table describes the labels in this screen.
Table 52 Network Setting > QoS > Policer Setup
LABEL
Add New
Policer
#
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Select to enable or disable this shaper.
Select the VMG's interface through which traffic in this shaper applies.
Enter the average rate limit of traffic bursts for this shaper.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Click this to create a new entry.
This is the index number of the entry.
VMG3925-B10A User's Guide
150