Bottom Panel With Product Label - NETGEAR ProSAFE WNDAP380R Reference Manual

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
The rear panel components of the wireless access point, from left to right, are described in
the following list:
1. Factory default Reset button. Using a sharp object, press and hold this button for about
10 seconds to reset the wireless access point to factory defaults settings. All configuration
settings are lost, and the default password is restored. For more information, see
the Wireless Access Point to the Factory Default Settings
2. 10/100/1000BASE-T Gigabit Ethernet (RJ-45) port with Auto Uplink (Auto MDI-X) with
IEEE 802.3af Power over Ethernet (PoE) support for connection to a switch or router.
3. Cable security lock receptacle for an optional lock.
4. Power socket for a 12VDC, 1.5A power adapter.

Bottom Panel with Product Label

The product label on the bottom of the wireless access point's enclosure displays factory
default settings, regulatory compliance, and other information:
Figure 3. Product label on the bottom
on page 70.
Introduction
13
Restore