NETGEAR ProSAFE WNDAP380R Reference Manual page 89

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
Wireless client
Router
Internet
LAN segment 1
Figure 18. Point-to-point wireless network

To configure a point-to-point wireless network with or without client association:
1. Configure the wireless access point (AP1 on LAN Segment 1 in the previous figure) as
a point-to-point bridge:
a. Select Configuration > Wireless Bridge.
The Bridging screen displays (see the following figure).
b. (Optional) Click the 802.11a/na tab.
The Bridging screen lets you configure a point-to-point wireless network for the
802.11a/na modes.
c. Select the Enable Wireless Bridging check box.
The Local MAC Address field is a nonconfigurable field that shows the MAC address
of the wireless access point.
d. Select the Wireless Point-to-Point Bridge radio button.
AP1
Point-to-point
bridge mode
Advanced Configuration
89
AP2
Point-to-point
bridge mode
Hub or switch
LAN segment 2
Wireless client