Rear Panel - NETGEAR ProSAFE WNDAP380R Reference Manual

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
Table 1. Top panel LEDs
Item LED Description
1 Power/Test Off
2 Active
3 LAN
4 2.4 GHz WLAN
5 5 GHz WLAN

Rear Panel

Figure 2. Rear panel
On (green)
Amber, then blinking
green
Off
On or blinking (green) Ethernet traffic is detected.
Off
Amber
Green
Off
On or blinking (green) Wireless 802.11b/g/n (2.4 GHz) LAN is ready, or
Off
On or blinking (green) Wireless 802.11n/a (5 GHz) LAN is ready, or wireless
1
Introduction
12
Power is off.
Power is on.
A self-test is running or software is being loaded.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after one minute the
LED remains amber or continues to blink green, it
indicates a system fault.
No Ethernet traffic is detected, or no link is detected.
No link is detected on the LAN port.
100 Mbps or 10 Mbps link is detected on the LAN port.
1000 Mbps link is detected on the LAN port.
Wireless 802.11b/g/n (2.4 GHz) LAN is not ready, or
no wireless activity is detected.
wireless activity is detected.
Wireless 802.11n/a (5 GHz) LAN is not ready, or no
wireless activity is detected.
activity is detected.
2 3 4