Bottom Panel With Product Label And Reset To Factory Defaults Button - NETGEAR ProSAFE WN203 Reference Manual

ProSAFE Single Band 802.11n Wireless Access Point WN203
4. Power socket for a 12 VDC, 1A power adapter.
5. Reverse SMA connector for an optional 2.4 GHz antenna.
If you have purchased external antennas, see
page 70 for information about how to enable the external antennas.
Bottom Panel with Product Label and Reset to Factory
Defaults Button
The product label on the bottom of the wireless access point's enclosure displays factory
default settings, regulatory compliance, and other information. The bottom panel also
contains the recessed Reset to Factory Defaults button, which is indicated on the product
label.
Console
2.4 Ghz
Single Band 802.11n Wireless Access Point
This device complies with part 15 of the FCC Rules and Canada ICES-003.
Operation is subject to the following two conditions: (1) this device may not
Reset to
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Factory Defaults
Designed by NETGEAR in California
Figure 3. Product label on the bottom

To reset the wireless access point to factory default settings:
Use a sharp object to press and hold the Reset to Factory Defaults button for about
10 seconds.
All custom configuration settings are lost, and the default password is restored. For more
information, see Restore the Wireless Access Point to the Factory Default Settings
page 58.
Configure Advanced Wireless Settings
LAN
http://192.168.0.100
user name: admin
password: password
MAC
FCC ID: PY312400222
SERIAL
IC: 4054A-12400221
Made in China
Reset to Factory Defaults button
Introduction
13
Power
2.4 Ghz
12V 1.0A
272-11850-02
on
on