NETGEAR ProSAFE WNDAP380R Reference Manual page 144

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
| | |-port
| | |-server
| | |-status
| |
| |-time-settings>
| | |-ntp>
| | | |-client
| | | |-custom-server
| | | |-server
| | |
| | |-timezone
| |
| |-vlan>
| | |-management-vlan
| | |-untagged-vlan id
| | |-untagged-vlan-status
| |
|
|-exit
|-firmware-upgrade
|
|-firmware-upgrade-tftp
|
|-reset-ap
|-restore-configuration
|-restore-default-password
|-restore-factory-default
|-save-and-activate
|-show>
| |-country
| |-dhcp
| |-ethernet>
| | |-statistics
| |-hotspot--Show hotspot settings
| |-ip>
| | |-config
| | |-status
| |-log
| |-name
| |
| |-radio>
| | |-2.4
| | |-2.4>
| | | |-associated-client
| | | |-macacl
| | | |
| | | |-rogue-ap-detection>
| | | | |-known>
--Syslog server port number
--Syslog server IP address
--Enable syslog client
--Time Setting
--NTP sever settings
--Client enable
--Custom server enable
--Server host name
--Time zone
--VLAN settings
--VLAN management-id
--Untagged VLAN-id
--Untagged vlan status
--Logout from CLI
--Upload new system firmware file fromftp
server
--Upload new system firmware file
fromtftp server
--Reset the ap
--Restore system configuration
--Restore default system password
--Restore default system configurations
–-Save and activate configuration
--Show system settings
--Show Country
--Show DHCP settings
--Ethernet interface
--Show ethernet statistics
--IP settings
--Show IP configurations
--Show IP status
--Show system logs
--Show ap name
--Show 2.4GHz wlan interface settings
--2.4GHz wlan interface settings
--Associated client(s)
--Wireless access control (ACL) mac
address list
--Rogue ap detection
--Known
Command-Line Reference
144