Configure Rfid Settings; Enable The Rfid Module And Configure The Rfid Server - NETGEAR ProSAFE WNDAP380R Reference Manual

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
Note: Between each LAN segment, you can extend repetition of the
wireless signal by adding up to two more wireless access points that
are configured in point-to-multipoint bridge mode without client
association.

Configure RFID Settings

The wireless access point integrates a radio-frequency identification (RFID) module. This
RFID module can collect data from RFID tags and devices and forward the data to an RFID
server (a computer that is running RFID software).
Note: The wireless access point and integrated RFID module cannot
configure the RFID tags and devices. The RFID module passes on
traffic from the RFID tags and devices to the RFID server.

Enable the RFID Module and Configure the RFID Server

For the integrated RFID module to communicate with one or more RFID servers, you need to
configure the RFID server connection type, IP addresses, and port numbers.

To enable the RFID module and configure RFID servers:
1. Select RFID > Configuration.
The RFID (configuration) screen displays:
Advanced Configuration
103