NETGEAR ProSAFE WNDAP380R Reference Manual page 22

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
Tip: If you enable the DHCP client on the wireless access point, you can
discover the new IP address of the wireless access point by accessing
the DHCP server on your LAN, or by using a network IP address scanner
application.

To configure the IP settings:
1. Select Configuration > IP > IP Settings.
The IP Settings screen displays:
2. Configure the IP settings as explained in the following table:
Setting
DHCP Client
IP Address
IP Subnet Mask
Default Gateway
Description
By default, the Dynamic Host Configuration Protocol (DHCP) client is disabled. If
you have a DHCP server on your LAN and you select the Enable radio button,
the wireless access point receives its IP address, subnet mask, and default
gateway settings automatically from the DHCP server on your network when you
connect the wireless access point to your LAN.
Enter the IP address of your wireless access point. The default IP address is
192.168.0.100. To change the address, enter an unused IP address from the
address range used on your LAN, or enable DHCP the server.
Enter the network number portion of an IP address. Unless you are
implementing subnetting, enter 255.255.0.0 as the subnet mask.
Enter the IP address of the ISP gateway to which the wireless access point
connects.
Installation and Basic Configuration
22