Configure Hotspot Settings - NETGEAR ProSAFE WNDAP380R Reference Manual

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
2. Specify the settings as explained in the following table:
Setting
Spanning Tree Protocol
Spanning Tree Protocol Select the Enable radio button to enable STP to prevent path redundancy. By
802.1Q VLAN
Untagged VLAN
Management VLAN
3. Click Apply.

Configure Hotspot Settings

If the wireless access point functions as a public access point and you want it to capture and
redirect all HTTP requests (over TCP, port 80), set up a hotspot server to redirect the
requests to the specified URL and manage the clients. For example, you can redirect HTTP
requests to a web server for authentication, timing control, or advertising. A hotel might want
all wireless connections to go to its server to start a billing transaction.
Description
default, the Disable radio button is selected.
Select the Untagged VLAN check box to configure one VLAN as an untagged
VLAN. By default, the Untagged VLAN check box is selected.
Specify a VLAN ID. The default VLAN ID is 1.
Specify an ID for the VLAN from which the wireless access point can be
managed. The default VLAN ID is 1.
Note: If you configure the management VLAN ID as 0 (zero), the wireless access
point can be managed over any VLAN, and frames that belong to the
management VLAN are not tagged with an 802.1Q header when sent over the
trunk.
Advanced Configuration
81