Restore The Configuration; Restore The Wireless Access Point To The Factory Default Settings - NETGEAR ProSAFE WNDAP380R Reference Manual

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

Restore the Configuration

IMPORTANT:
During the restoration process, do not try to go online, turn off the
wireless access point, shut down the computer, or do anything else
to the wireless access point until it finishes restarting!

To restore your settings from a saved configuration file:
1. Select Maintenance > Upgrade > Restore Settings.
The Restore Settings screen displays:
2. Click Browse.
3. Locate the backup configuration file (the file name is config).
4. Click Apply.
The restoration process is initiated. During the restoration process, the wireless access
point automatically restarts. The restoration process typically takes about one minute.
When the Test LED turns off, wait a few more seconds before doing anything with the
wireless access point.
Restore the Wireless Access Point to the Factory Default
Settings
You can restore the wireless access point to the factory default settings by two methods that
are described in the following sections:
• Use the Web Management Interface to Restore Factory Default Settings
• Use the Reset Button to Restore Factory Default Settings
Management
70