Bottom Panel With Ethernet Ports - NETGEAR AirBridge WBC502 Hardware Installation Manual

Insight Instant AirBridge WBC502 Hardware Installation Guide

Bottom panel with Ethernet ports

The following figure shows the bottom panel with the cover removed.
Figure 3. Bottom panel with the cover removed
The bottom panel of the AirBridge is covered. When you remove the cover (see Front
panel on page 12), the following components display:
1. Reset button. Recessed Reset button (see Reset button on page 18).
2. LAN1 (PoE-24V) port. One 10/100/1000BASE-T RJ-45 PoE port that provides both
PoE power and network connectivity to the AirBridge.
Using an Ethernet cable, connect the LAN1 port on the AirBridge to the PoE port
on the supplied power adapter (see Power adapter on page 16) that is supplied in
the package. For an AirBridge that functions as a master in a master-to-satellite setup
or as an access point (either in an access point-to-client bridge setup or as standalone
access point) at a main site, the network can include wired Internet access.
WARNING: Power the AirBridge only with an Ethernet cable that is connected from
the LAN1 port to the PoE port on the supplied power adapter. Do not use any other
power source such as a PoE switch. The LAN1 port is not a standard PoE port. Using
any other power source could damage the device.
3. LAN2 port. One 10/100/1000BASE-T RJ-45 port that allows you to connect an
optional single device (such as an IP camera) directly to an AirBridge that functions
as a client bridge at a detached site.
Hardware Overview
1
3
15
2
Hardware Installation Guide