NETGEAR ProSAFE WNDAP380R Reference Manual page 132

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
| |-no>
| | |-dhcp>
| | | |-dns1
| | | |-dns2
| | | |-wins1
| | | |-wins2
| | |-radius>
| |
| | | |-primary>
| | | | |-auth port
| | | | |-acct port
| | | | |-auth server
| | | | |-acct server
| | | |-secondary>
| | | | |-auth port
| | | | |-acct port
| | | | |-auth server
| | | | |-acct server
| |-radio>
| | |-2.4
| | |-2.4>
| | | |-80211d
| | | |-aggregation-length
| | | |-ampdu
| | | |-beacon-interval
| | | |-channel
| | | |
| | | |-channel auto
| | | |-channel-width
| | | |-client-isolation
| | | |-data-rate
| | | |-dtim
| | | |-fragmentation-length
| | | |-guard-interval
| | | |
| | | |-macacl add
| | | |-macacl del
| | | |-macacl del all
| | | |
| | | |-max-client
| | | |-power
| | | |-preamble-type
| | | |
| | | |-rifs-transmission
| | | |
| | | |-rogue-ap-detection
| | | |-rogue-ap-detection knownap add
| | | |-rogue-ap-detection knownap del MAC
--Reset
--DHCP server settings
--DNS1 server
--DNS2 server
--WINS1 server
--WINS1 server
--Radius server setting
--Primary server
--Authentication port
--Accounting port
--Authentication server
--Accounting server
--Secondary server
--Authentication port
--Accounting port
--Authentication server
--Accounting server|
--Wireless LAN interface setting
--2.4 GHz wireless LAN status
--2.4 GHz wireless LAN interface setting
--802.11d enable
--Aggregated packet size
--Aggregated MAC Protocol Data Unit
--Wireless beacon period in TU(1024 us)
--Wireless channel (depends on country
and wireless mode)
--Set wireless channel to auto mode
--Wireless channel width
--Client isolation status
--Wireless transmission date rate
--Wireless DTIM period in beacon interval
--Wireless fragmentation threshold
--Interval (from interference from other
transmissions)
--Add wireless access control (ACL)
--Delete wireless access control (ACL)
--Delete wireless access control (ACL)
Database
--Maximum client
--Output power
--Wireless preamble (only effect on
802.11b rates)
--Enable successive frame transmission
at different transmit
--Enable rogue access point detection
--Add rogue access point detection
--Delete rogue access point detection
Command-Line Reference
132