Rear Panel - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
Table 1. Top panel LEDs (continued)
Item LED Description
2.4
5 WLAN
Ghz
5
6 WLAN
Ghz

Rear Panel

1
Figure 2.
The rear panel components of the wireless access point, from left to right, are described in
the following list:
1. First reverse SMA connector for an optional 2.4 GHz antenna.
2. Factory default Reset button. Using a sharp object, press and hold this button for about
5 seconds to reset the wireless access point to factory defaults settings. All configuration
settings are lost, and the default password is restored. For more information, see
the Wireless Access Point to the Factory Default Settings
3. First 10/100/1000BASE-T Gigabit Ethernet (RJ-45) port with Auto Uplink (Auto MDI-X) with
IEEE 802.3af Power over Ethernet (PoE) support for connection to a switch or router.
4. Second 10/100/1000BASE-T Gigabit Ethernet (RJ-45) port with Auto Uplink (Auto MDI-X)
with IEEE 802.3af Power over Ethernet (PoE) support for connection to a switch or router.
5. Second reverse SMA connector for an optional 2.4 GHz antenna.
6. Console port for connecting to an optional console terminal. The port has an RJ-45
connector and supports the following settings: 9600 K default baud rate, 8 data bits, no (N)
parity bit, and one (1) stop bit.
7. Cable security lock receptacle for an optional lock.
Off
On or blinking (green) Wireless 802.11b/g/n (2.4 GHz) LAN is ready, or
Off
On or blinking (green) Wireless 802.11n/a (5 GHz) LAN is ready, or wireless
2 4
3 5
Introduction
13
Wireless 802.11b/g/n (2.4 GHz) LAN is not ready, or
no wireless activity is detected.
wireless activity is detected.
Wireless 802.11n/a (5 GHz) LAN is not ready, or no
wireless activity is detected.
activity is detected.
8
6 7
on page 71.
9
Restore