Scanning Problems - Fuji Xerox DocuPrint M255 z User Manual

Scanning Problems

Problem
The scanner does not work.
The printer scans very slowly.
Document misfeeds or multiple
feeds occur in the ADF.
Vertical stripes appear on the
output when scanned using the
ADF.
A smear appears at the same
location on the output when
scanned using the document
glass.
Images are skewed.
Diagonal lines appear jagged
when scanned using the ADF.
Action
Ensure that you place the document to be scanned face down on the
document glass, or face up in the Automatic Document Feeder
(ADF).
There may not be enough available memory to hold the document
you want to scan. Try the Preview feature to see if that works. Try
lowering the scan resolution rate.
Check that the USB cable is connected properly.
Ensure that the USB cable is not defective. Switch the cable with a
known good cable. If necessary, replace the cable.
Check that the scanner is configured correctly. Check the application
you want to use to make certain that the scanner job is being sent to
the correct port.
Graphics are scanned more slowly than text when using the Scan to
E-Mail or Scan to Network feature.
Communication speed becomes slow in scan mode because of the
large amount of memory required to analyze and reproduce the
scanned image.
Scanning images at a high resolution takes more time than scanning
at a low resolution.
Ensure that the document's paper type meets the specifications for
the printer.
See also:
• "Preparing a Document" on page 183
• "Making Copies From the Automatic Document Feeder (ADF)" on
page 186
Check whether the document is properly loaded in the ADF.
Ensure that the document guides are adjusted properly.
Ensure that the number of document sheets do not exceed the
maximum capacity of the ADF.
Ensure that the document is not curled.
Fan the document well before loading it in the ADF.
Clean the ADF glass.
See also:
• "Cleaning the Scanner" on page 395
Clean the document glass.
See also:
• "Cleaning the Scanner" on page 395
Ensure that the document is loaded straight in the ADF or on the
document glass.
If the document uses thick media, try scanning it from the document
glass.
Troubleshooting 375