• Interval Timer
Purpose:
To specify an interval between transmission attempts within the range of 3 to 255 seconds. The
default is 8 seconds.
• Number of Redial
Purpose:
To specify the number of redial attempts to make when the destination fax number is busy, within the
range of 0 to 9. If you specify 0, the printer will not redial. The default is 3.
• Redial Delay
Purpose:
To specify an interval between redial attempts within the range of 1 to 15 minutes. The default is 1
minute.
• Junk Fax Filter
Purpose:
To reject faxes from the numbers that are not included in the Address Book.
Values:
Off*
On
*
Factory default menu setting
NOTE:
•
Ensure to register the fax numbers you want to accept faxes from in the Address Book before using Junk
Fax Filter.
• Remote Receive
Purpose:
To receive a fax by pressing the remote receive code on the external telephone after picking up the
handset of the telephone.
Values:
Off*
On
*
Factory default menu setting
• Remote Rcv Tone
Purpose:
To specify the remote receive code in two digits to start the Remote Receive action. As the factory
default menu setting, 00 is specified in advance.
300
Using the Operator Panel Menus and Keypad
Accepts all faxes.
Rejects faxes sent from the numbers that are not included in the
Address Book.
You cannot receive a fax by pressing the remote receive code on the
external telephone.
You can receive a fax by pressing the remote receive code on the
external telephone.