Fuji Xerox DocuPrint M255 z User Manual page 118

Auto Setup With the Access Point
If the access point such as a wireless router supports the WPS, security settings can be made
automatically.
• WPS-PBC
NOTE:
• WPS-PBC is a method to authenticate and register devices required for wireless configuration, by pressing
the button provided on the access point via wireless routers, and then performing WPS-PBC setting on the
operator panel. This setting is available only when the access point supports WPS.
1
On the operator panel, press the
2
Select Admin Menu, and then press the
3
Select Network, and then press the
4
Select WPS Setup, and then press the
5
Select Push Button Control, and then press the
6
Select Yes, and then press the
7
Press and hold the WPS button on the access point.
8
Wait a few minutes until the printer restarts to establish the wireless network.
9
Print a System Settings page from the operator panel.
Press the
a
Select Report/List, and then press the
b
Select System Settings, and then press the
c
The System Settings page is printed.
10
Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
• If the wireless setting does not work, contact your system administrator or Fuji Xerox Customer Support
Center.
118 Printer Connection and Software Installation
(System) button.
button.
(System) button.
button.
button.
button.
button.
button.
button.