Sending A Fax Manually; Confirming Transmissions - Fuji Xerox DocuPrint M255 z User Manual

Sending a Fax Manually

1
Load a document(s) face up on the Automatic Document Feeder (ADF) with the top edge going
in first; or place a single document face down on the document glass and close the document
cover.
See also:
• "Loading a Source Document on the Automatic Document Feeder (ADF)" on page 249
• "Loading a Source Document on the Document Glass" on page 250
2
Press the (Fax) button.
3
Adjust the document resolution to suit your fax needs.
See also:
• "Resolution" on page 251
• "Lighten/Darken" on page 252
4
Select OnHook, and then press the
5
Select On, and then press the
6
Enter the fax number of the remote fax machine using the numeric keypad.
7
Start the fax transmission.
• If the document is loaded on the ADF, press the
• If the document is loaded on the document glass, press the
desired setting, and then press the
NOTE:
• You can cancel your fax job at any time by pressing the

Confirming Transmissions

When the last page of your document has been sent successfully, the printer beeps and returns to
standby mode.
If something goes wrong while sending your fax, an error message appears on the LCD panel.
If you receive an error message, press the
document again.
You can set your printer to print a confirmation report automatically after each fax transmission.
See also:
• "Printing a Report" on page 279
254 Faxing
button.
button.
(Start) button.
button.
(Stop) button while the transmission is in progress.
button to clear the message and try sending the
(Start) button, select the