Fuji Xerox DocuPrint M255 z User Manual page 119

• WPS-PIN
NOTE:
• WPS-PIN is a method to authenticate and register devices required for wireless configuration, by entering PIN
code to a printer and computer. This setting, performed through access point, is available only when the
access points of your wireless router supports WPS.
• Before WPS-PIN starts, you will need to enter your PIN code at the web page of the wireless access point.
See the access point manual for the details.
1
On the operator panel, press the
2
Select Admin Menu, and then press the
3
Select Network, and then press the
4
Select WPS Setup, and then press the
5
Select PIN Code, and then press the
6
Take a note of PIN code displayed on the operator panel.
7
Select Start Configuration, and then press the
8
If SSID selection screen appears, select the SSID, and then press the
9
Enter the PIN code of the printer at the web page of the wireless access point.
10
Wait a few minutes until the printer restarts to establish the wireless network.
11
Print a System Settings page from the operator panel.
Press the
a
Select Report/List, and then press the
b
Select System Settings, and then press the
c
The System Settings page is printed.
12
Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
• If the wireless setting does not work, contact your system administrator or Fuji Xerox Customer Support
Center.
(System) button.
(System) button.
button.
button.
button.
button.
button.
button.
button.
Printer Connection and Software Installation
button.
119