Scanning Problems - Fuji Xerox DocuPrint CM115 w User Manual

Scanning Problems

Problem
The scanner does not work.
The printer scans very slowly.
A smear appears at the same
location on the output when scanned
using the document glass.
Images are skewed.
The printer does not properly transfer
scan data to a specified destination
via the Scan to E-Mail or Scan to
Network feature.
Cannot scan using Windows Image
Acquisition (WIA) on a Windows
®
Server 2003 computer.
226 Troubleshooting
Action
Make sure that you place the document to be scanned facing down on the
document glass.
There may not be enough available memory to hold the document you want to
scan. Try the Preview function to see if that works. Try lowering the scan
resolution rate.
If you are using wireless connection, make sure that the wireless connection is
established.
If you are using USB connection, make sure that you are using the correct USB
cable and that it is securely connected to the printer.
Make sure that the USB cable is not defective. Switch the cable with a known
good cable. If necessary, replace the cable.
Check that the scanner is configured correctly. Check the application you want to
use to make certain that the scanner job is being sent to the correct port.
Graphics are scanned more slowly than text when using the Scan to E-Mail or
Scan to Network feature.
Communication speed becomes slow in scan mode because of the large amount
of memory required to analyze and reproduce the scanned image.
Scanning images at a high resolution takes more time than scanning at a low
resolution.
Clean the document glass.
See also:
• "Cleaning the Scanner" on page 242
Make sure that the document is placed straight on the document glass.
Check if the following settings have been set correctly on the CentreWare Internet
Services.
Scan to E-Mail
Check the following setting under Address Book  Personal Address:
• Name
• E-mail Address
Scan to Network
Check the following settings under Address Book  Computer/Server Address
Book:
• Name (Displayed on Printer)
• Network Type
• Host Address (IP Address or DNS Name)
• Port Number
• Login Name (if required by host)
• Login Password
• Name of Shared Directory
• Subdirectory Path (optional)
Enable Windows Image Acquisition (WIA) on the computer.
To enable Windows Image Acquisition (WIA):
1 Click Start, point to Administrative Tools, and then click Services.
2 Right-click Windows Image Acquisition (WIA), and then click Properties to
make sure that Startup type is set to Manual or Automatic.
3 Click OK.
4 Right-click Windows Image Acquisition (WIA), and then click Start.