Transfer Ringing Return 2-11; Ringing Line Pickup - Mitel Panther II 820 System Manual

Panther II 820/1032/2064-205
Class B' - dialing any of the preprogrammed entries from "Deny
Table B" or dialing the number of "Digits to Deny" when Behind
PBX/Centrex, or dialing a restricted Common Speed number from the
"Split Restriction Table for Class B" will restrict a call.
Class C - no outside calls can be made, except those telephone
numbers beginning with preprogrammed entries included in "Allow
Table C", or dialing Common Speed Call numbers that are unrestricted
in the "Split Restriction Table for Class C".
Class C' - no outside calls can be made.
Preprogrammed Value = Class A.
TRANSFER RINGING RETURN: After TRANSFER
RINGING TIME has been set in System Programming, this feature
defines where unanswered Transfer Ringing to each Set will return.
Parameters included: no return, return to originator then sub-attendant,
OR return to sub-attendant. If sub-attendants are not used (see Multiple
Attendants - System Programming), ringing returns to the master
station.
Preprogrammed Value = Returns to originator, then sub-attendant.
RINGING LINE PICKUP: Determines whether or not each
station will have ringing line pickup capability. This allows the user to
answer any call simply by going off-hook, pressing the Speaker key,
or dialing 9. Calls will be picked up in the following order: C.O.
incoming ringing, Transfer ringing, then Intercom (internal) ringing.
Ringing Line Pickup works at all sets regardless of whether the set is
programmed for Auto Line Select, Auto Intercom or Manual Select.
Preprogrammed Value = Ringing Line Pickup capability at each station.
DO NOT DISTURB (DND) OVERRIDE: Determines whether
or not each station will have DND Override capability. This feature
allows the user to override other users who have Do Not Disturb
activated at their Set. The capability should only be given as an
executive or attendant privilege.
Preprogrammed Value = Only Master Set has DND Override capability.
Programming
Page 31