Table of Contents
Advertisement
Mite1 Standard Practise
Programming Automatic
Access.
to a Voice Mail System
5.03
You can program the ONS Unit to allow Panther station users to forward their
calls directly to their voice mailboxes.
When the system has been programmed
for auto-
matic access people can redirect their incoming calls to their voice mailboxes simply by
call forwarding their sets to the ONS station number of the voice mail system
To enable automatic access, you must program DTMF digit strings into the ONS Unit
that will allow the voice mail system identify the type of calls and the stations' voice
mailboxes.
You program the DTMF digit strings and the voice mailbox numbers from
the Master Attendant Station. After programming
the DTMF digits strings and voice
mailbox numbers, you have the option of setting conditions to automatic access.
In addition, you may have to change the default settings of some of the following para-
meters to allow the automatic access feature to work with your type of voice mail system:
l
DTMF Digit Timing
l
Pause Duration
l
Transfer Ringing Time
l
Tone/Pulse C.O. Lines
You program the parameters listed above from station 10.
Programming
DTMF Digit Strings for Automatic Access
To program the type of calls:
Step 1
Go to the Panther II Display Set at the Master Attendant Station.
Step 2
Press the Speed key. The Intercom lamp winks slowly and the display is
blank.
Step 3
Enter the 3-digit code (from Table 5-5) that corresponds to the type of call.
The code will appear in the display as you enter it. For example, if you enter
#80 the display will appear as follows:
Display Set LCD
Feature Module IV & On Premise Station Unit
Page 30
Advertisement
Chapters
Table of Contents
