Smdr Startup Operation - Mitel Panther II 820 System Manual

Trillium Standard Practice
SMDR Startup Operation
2.16
Time and date setting used by the SMDR Unit is set automatically when the
system clock is programmed from Station 10. (See "Setting Date/Time" procedures
outlined in the Panrher !I Display Ser Guide for instructions).
If the system has already
been in operation and the SMDR option is added later, there is no need to set the Sh4DR
clock. Refer to Panther II 820/1032/2064-200, Installation and Commissioning for
installation instructions. Date and time information is maintained in memory, even
during power failures.
NOTE: Even though the year does not appear on the printout, it must be entered as part of the date
so that the SMDR can compensate f&leap years.
TABLE 2-10
SAMPLE SMDR PRINTOUTS
Incoming data 'appears on the printout as follows:
07/23 03:22P 00:11:53 TOO3
Day of Month
Jlonth of year
c
029
001 Al234
I
station that
'Account
'Ode
answered the call
Number of seconds to answer call
I
Line call came in on
-
T stands for trunk
Call Length
-
Seconds
Call length
-
Minutes
Call length
-
Hours
PM time
-
no designation for AM
rime of day
-
Minutes
rime of day
-
Hours
Programming
Page 28
.