Mite1 Standard Practise
5. ON PREMISE STATION UNIT PROGRAMMING
General Programming
5.01
This chapter provides programming
instructions for the ONS Unit. The program-
ming parameters for the ONS Unit and ONS stations are listed in the tables of this chapter.
To program ONS features:
Step 1
Dial *#015 on the Panther II Display Set at Station 10
Step 2
Select the desired feature from the table and dial the appropriate 3- to 7-digit
access code.
Step 3
To change the default, dial the data code of the desired setting.
Step 4
Press the # key to store the data.
Step 5
Repeat steps 2 to 4 for each system feature setting or each ONS station setting
that you wish to change.
Step 6
Press the * key to exit programming.
The new programming
is complete
ONS Unit Flash-Hook Recognition
You can
program the flash-hook signal that is generated at an ONS device to be recognized
by the ONS Unit as either a hold, flash, cancel or transfer. The flash-hook signal for Pan-
ther sets is not the same signal and is programmed
separately using a different access code
(access code 055 changes the function of the ONS flash-hook, access code 005 changes the
function of the Panther system flash-hook).
FVNCTION
Hold
0
A flash-hook performed at a single-line set,
voice mail system or auto attendant signals the
ONS Unit that a call is to be held
055
I
Flash
I
1
I
Network flash
r--
Cancel
I
2
I
Network cancel
Transfer
3
A flash-hook performed at a single-line set,
voice mail system or auto attendant signals the
ONS Unit that a call is to be held and transferred
Default: Cancel
Table 5-1: ONS Unit Flash-hook Recognition
Feature Module IV & On Premise Station Unit
Page 24
.'