Reseting The Digit Strings And Voice Mailbox Numbers; Setting Conditions To Automatic Access - Mitel Panther II 820 System Manual

Mite1 Standard Practise
To confii the mailbox numbers that you' ve stored:
Step 1
Press the Display key on the Panther II Display Set at the Master Attendant
Station. The Intercom lamp turns on steady and the display is blank.
Step 2
Press the Speed key.
Step 3
Enter the #YY where IT is the station number. The voice mailbox number
for that station will be displayed.
Step 4
Repeat steps 2 and 3 for each mailbox number that you wish to confirm.
Step 5
Press the Display key. The Intercom lamp turns off. The display returns to
showing the date and time.
Reseting the Digit Strings and Voice Mailbox Numbers
You can reset the digit strings (for the type of call) and the voice mailbox numbers to the
default settings. Note that the following procedure also clears all common speed dial
numbers and/or all private speed call numbers.
To reset the digit strings and/or the voice mailbox numbers:
Step 1
Dial *##015 on the Panther II Display Set at Station 10
Step 2
Dial 0701# to reset the data strings for the types of call. Note that all common
speed dial numbers will also be cleared.
and/or
Step 3
Dial 0702# to reset the voice mailbox numbers. Note that all private speed
dial numbers will also be cleared.
Dial * to exit programming mode.
Setting Conditions to Automatic Access
You can program the system to impose conditions on automatic access to the voice mail
system. The system checks the validity of the data string for the type of call and the
validity of the origin of the call (station or line number). If the data meets the pro-
grammed conditions, access to the voice mail system will be allowed. If the data doesn' t
meet the programmed conditions, access will be denied. These conditions don' t apply to
the Message Waiting signal that' s sent from the voice mail system to the ONS Unit.
To program conditions to automatic access:
Step 1
Dial *#015 on the Panther II Display Set at Station 10
Step 2
Dial access code 058.
Step 3
Enter data code of the desired condition (Table 5-7)
Step 4
Press the # key to store the data
Step 5
Press the * key to exit programming
Feature Module IV & On Premise Station Unit
Page 34