Tone/Pulse C.o. Lines - Mitel Panther II 820 System Manual

Panther II 820/1032/2064-297
To program the Transfer Ringing Time
Step 1
Dial *#015 on the Panther II Display Set at Station 10
Step 2 Dial access code 017
Step 3 Enter data code of the desired setting (Table' S- 10)
Step 4 Press the # key to store the data
Step 5 Press the * key to exit programming
FEATURE
ACCESS
CODE
CONDITIONS
DATA
CODE
10 seconds
0
20 seconds
1
Transfer
30 seconds
2
Ringing
017
Time
45 seconds
3
1 minute
4
1.5 minute
5
Until call is Answered 6
Defaulr
30 seconds
Table S-10: Transfer Ringing Time
l
Tone/Pulse C.O. Lines
This
programming parameter determines the type of dialing, tone or pulse, for each C.O.
line that is connected to the system. If the C.O. lines that are connected to your system
can receive either tone or pulse signals, program the system for tone type C.O. lines.
To program the system for tone type C.O. lines:
Step 1 Dial *Ml5 on the Panther II Display Set at Station 10
Step 2 Dial access code 060xX where XX is the line number
Step 3 Enter data code 0
Step 4 Press the # key to store the data
Step 5 Repeat Steps 2 to 4 for each C.O. line
Step 6 Press the * key to exit programming
FEATURE
Tone/Pulse
Tw
ACCESS CODE
060xX
CONDITIONS
DATA CODE
Tone
0
Pulse
1
Defauk Tone
TABLE 5-11: Tone/Pulse 60. Lines
Feature Module IV & On Premise
Station Unit
Page
37