Account Code Type; Programming - Mitel Panther II 820 System Manual

Trillium Standard Practice
ACCOUNT CODE TYPE:
Specifies whether the system will
accept Forced or Manual Account Codes from a station. Refer to
Panther II 820/1032/2064-105, Features and Services for details. This
code is completed in conjunction with FORCED/MANUAL
ACCOUNT CODE DIGITS in System Programming.
Preprogrammed Value = Manual Account Codes.
STATION SECURITY: (Use Table 2-lla).
Determines
whether or not a station user must dial the Station Security Code, to
have access to an outside C.O. line when the system is in Security
Mode. Preprogrammed choices are:
l
High Level Privilege - This user does not need to dial a Station
Security Co& at any time. This is the preprogrammed value for all Sets.
._-
l
Day Level Pn'vilege - This user does not need to dial the code
when the system is in Day Mode, but must dial the Station Security
code in order to have access to an outside line when the system is in
Night Mode.
l
Night Level Privilege - This user must dial the code when the
system is in Day Mode, but does not need to dial the Security code
during Night MO&. This programming choice is typically reserved for
those users which do not use the system in Night Mode.
l
Low Level Privilege - This user must dial the Station Security
code at all times, in order to have access to an outside line.
FYeprogramrned Value = High Level Privilege.
ONE TOUCH SPEED DIAL / AUTO LINE HOLD:
This
feature allows you to place a call on hold simply by pressing a DSS key
and then transfer the call by announcing to the person at the station to
pick up the line that the call is on. This capability is assigned on a set-
by-set basis. If Auto Hold is not programmed, the user will have One
Touch Speed Dial Capability, where speed dialing is available by
pressing a DSS key.
Preprogrammed Value = One Touch Speed Dial.
RELAY CONTROL:
Determines if an individual station will have
access to relay-controlled equipment. This code is completed AFTER
Loud Bell/Relay Control parameters have been set in System
Programming.
Preprogrammed Value = No Relay access.
Programming
Page 32