Table of Contents
Advertisement
Panther II 820/1032/2064-297
The hold and transfer signals generated by the ONS unit are produced only within the
Panther system, whereas the flash and cancel signals are generated both within the Pan-
ther system and on the central office lines.
If you are connecting an auto attendant to an ONS port, or if you want to be able to trans-
fer calls from a single-line set, you must program the flash-hook as a Transfer signal.
You can set the ONS Flash/Cancel Recognition
time to correspond to the Flash/Cancel
signal produced by the ONS device by adjusting the dipswitch located on the right-hand
side of the ONS Unit (refer to Figure 3-5 and Table 3-8).
Type of ONS Device
Each ONS station supports either a single-line set, an auto attendant or a voice mail
system. You must program the type of device that you are connecting to the ONS station
because the system defaults to a Panther II Display Set at station 10 and Panther 1032/
2064 Sets at all other stations.
ACCESS CODE
TYPE OF ONS DEVICE
1OOYY
single-line set
voice mailbox
auto attendant
Default:
Panther II Display Set at station 10
Panther 1032/2064 Sets for all other stations
Note:
YY = station number (10 to 73)
Table 5-2: Type of ONS Device
DATA CODE
5
6
7
Manual Line Select/Auto Intercom/Auto
C.O.
If you' re connecting a single-line set to an ONS station, you should program the ONS
station for Manual Line Select. If the single-line set isn' t programmed
for Manual Line
Select, you' ll be unable to access both internal and external lines from the set.
If you' re connecting an auto attendant or voice mail system, leave the ONS station with
the default value of Auto Intercom.
If a voice mail system isn' t programmed
for Auto
Intercom, it can' t send a message waiting signal to a Panther station that has a voice mail
message.
Feature Module IV & On Premise Station Unit
Page 25
Advertisement
Chapters
Table of Contents
