Replacing The Feature Module Cartridge - Mitel Panther II 820 System Manual

Panther II 820/1032/2064-297
Replacing the Feature Module Cartridge
The following instructions detail the replacement of a Feature Module Cartridge in an ex-
isting installation.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
UNPLUG THE KSU POWER CORD. Telephone service will be discon-
nected.
Remove the Feature Module Cartridge protective cover. The protective cover,
located half-way down the right-hand side of the KSU, is secured by two
screws and two plastic expansion plugs. Loosen the two screws, pull back the
plastic expansion plugs and remove the protective cover.
Unplug the installed Feature Module Cartridge from the port on the side of the
KSU.
There are two small grooves on the Feature Module IV Cartridge connector.
Holding the replacement Feature Module IV Cartridge so that the grooves are
facing you, plug it securely into the port on the KSU (refer to the close-up
shown in Figure 2-I).
Plug in the KSU power cord.
Replace the protective cover over the Feature Module IV Cartridge, push in
the plastic expansion plugs, and tighten the two screws.
Set the MEM. CLEAR Switch to the ON position. The MEM. CLEAR Switch
(dipswitch #2) is located on the right-hand side panel of the KSU.
Press the RESET Switch.
Set the MEM. CLEAR Switch to the OFF position. The system is now reset to
the default settings.
Ensure the BATTERY Switch for the KSU memory is in the ON position.
The Battery Switch (dipswitch #4) is located on the right-hand side panel of
the KSU.
You must now program the system with the customer' s feature selections.
Refer to the PROGRAMMING PRACTICE in the PANTHER II SYSTEM
MANUAL for instructions. Programming instructions for the additional
q
features provided by Feature Module IV software and the On Premise Station
Unit are given in this Practice.
Feature Module IV & On Premise Station Unit
Page 3