Loud Bell Dry Contact - Mitel Panther II 820 System Manual

Panther II 820/1032/2064-105
telephone Sets. There is one primary line pool with an unlimited number of
lines, and three other pool groups with an unlimited number of lines per
group.
If a line pool key is not available, a code can be dialed to select the line pool.
This allows Sets such as the Panther II Set (Basic Set) to access line pools.
The codes for selecting line pools are as follows:
Line Pool
Code
1 401
; 403 402
4 404
When the line pool key is pressed, the system selects the first available line
in the pool group. If all lines are busy, the user can queue for the first
available line in the pool group.
NOTE: It is recommended that a key be programmed for the primary line
pool, and that the primary line pool be made up of local lines. The
programmer decides which C.O. line key on each station Set will be
+eplaced" by a line pool.
Conditions
l
Only "like" lines should go into a line pool (e.g., a pool is made up of all
"same area" WATS lines, FX lines, Local lines, and so on).
l
The same line will not be in more than one line pool group, however a
line can be both a line and a line pool on individual Sets.
Programming Required
l
Access Code 204 - Line Pooling Groups
l
Line Pool keys must be designated at each Set
LOUD BELL DRY CONTACTS
Description
An optional external ringer can be connected to the KSU by means of the
last cable pair on the X)-pin station connector (stations 10 to 17). This
feature provides a dry contact closure (no voltage) when there is an
incoming call. The system can be programmed for any or all lines to
activate the ringer, in both Day and Night mode.
Conditions
l
Since the same closure is used for Loud Bell and Relay Control, the
system must be programmed for one or the other.
Programming Required
l
Access Code 018 - Loud Bell / Relay Control
Features
and
Services
Page
15