Setting Conditions To Automatic Access; Dtmf Digit Timing - Mitel Panther II 820 System Manual

Panther II 820/1032/2064-297
ACCESS
CONDITION
FEATURE
DATA
CODE
DATA STRING
STATION/LINE NUMBER CoDE
Not Valid
Not Valid
0
Automatic
058
Valid
Not Valid
1
Access
Not Valid
Valid
2
Valid
Valid
3
Default: Data code 1
Note: This table doesn' t apply to the Message Waiting signal that' s sent from the VM system to the ONS
Unit
Table 5-7: Setting Conditions to Automatic Access
DTMF Digit Timing
When you dial
the voice mailbox from a Panther set, the DTMF tones generated by the
ONS Unit are true DTMF signals. However, for automatic access, you can adjust the
DTMF tone duration to the specific duration required by your voice mail system. Table
5-8 lists the possible tone durations that you can program for automatic access.
To
program
the duration of the DTMF tones
Step 1
Dial *##015 on the Panther II Display Set at Station 10
Step 2 Dial access code 056
Step 3
Enter data code of the desired setting (Table 5-8)
Step 4
Press the # key to store the data
Step 5
Press the * key to exit programming
FEATURE ACCESS CODE
DTMF TONE DURATION
DATA CODE
DTMF Tone
Approximately 100 ms* 0
Duration for
056
Approximately 200 ms 1
Automatic
Approximately 300 ms 2
Access
Approximately 400 ms 3
Notes: * = Default
Interdigit pause time is approximately 100 ms (fixed value)
Table 5-S: DTMF Digit Timing
Feature
Module IV & On Premise Station Unit
Page 35