Behind Pbxicentrex Programming - Mitel Panther II 820 System Manual

Panther II 820/1032/2064-205
TABLE 2-4 TYPE OF LINE PARAMETERS
Feature Access Condition
Data
Description Code
(Values)
Code
Tone/Pulse 06Oxx Tone*
0
Pulse 1
__~_________________~~~~~~~~~~~~~~~~--~~~~~~~~~~~~~~~---~-~~~~~~~~~~~~~-~--~~~~~~~~~~~~
C.O./PBX 061Xx Telephone (C.O.)* 0
PBXKentrex 1
Notes: *
denotes preprogrammed value
XX = a line number from 01 to 08 on the Panther II 820 system, or 01 to 10 on the Panther II
1032 system, or 01 to 20 on the Panther II 2064 system. To program these access codes, you
will need to enter each C.O. line number that needs to be changed from the preprogrammed
value (one at a time).
Behind PBX/Centrex Programming
2.11 The Behind PBXKentrex Programmin g must be completed when your Panther
II system will be connected to PBXKentrex lines. The parameters, including Access
Codes and Data Codes are provided in Table 2-5. They are:
PAUSE ON NUMBER: Instructs the system to pause after a
specific number is dialed as the first digit. It is employed when the
Panther II system is used behind a PBXKentrex to allow for second
dial tone. More than one number can be selected to activate a pause.
The digits specified by the Pause on Number parameters are; pause/no
pause on 7, pause/no pause on 8, pause/no pause on 9, pause/no pause
on 0.
Preprogrammed Value = No pause on any digit.
PAUSE TIME: Defines the duration of the pause for the "Pause on
Number" feature, and for a pause inserted in a speed dial number. The
pause time can be set to 1 second through 15 seconds, in l-second
intervals.
Preprogrammed Value = 3 seconds.
FLASH / CANCEL / TRANSFER: Defines the function of the
Plash/Ca.ncel key to be a hookswitch flash, a cancel signal for ending
calls, or a Transfer key to transfer calls automatically. The duration of
the Flash or Cancel signal must be properly set to ensure correct
operation (see FLASH/CANCEL TIMING).
Preprogrammed Value = Cancel.
Programming
Page 15