Installation - Mitel Panther II 820 System Manual

Mite1 Standard Practise
Installation
3.02 The On Premise Station (ONS) Unit connects to station ports on the left-hand side
of Panther II 820,1032 and 2064 KSUs. The ONS Unit supports up to four devices and
each device occupies a station port on the KSU. In order for the ONS unit to operate,
Feature Module IV software must be installed in the KSU.
You can connect a maximum of two ONS Units to a Panther II 820,1032 or 2064 Sys-
tem. However, you can' t connect an ONS Unit to more than one KSU. For example,
you can' t connect two ONS ports to a Panther II 820/1032/2064 KSU and connect the
other two ONS ports to another Panther II 820/1032/2064 KSU.
You can install or remove the ONS Unit without disconnecting power to the system or
interrupting service to all stations. In fact, the KSU must be receiving power when you
plug in the ONS power cord. If the KSU isn' t powered up when you plug in the ONS
power cord, the ONS unit may not operate properly. In addition, if you disconnect any of
the modular cords that connect the KSU stations to the ONS Unit, you must disconnect
the power to the ONS Unit, After reconnecting the modular cords, you can then plug in
the ONS power cord (providing that the KSU is receiving power).
If these procedures
aren' t followed, the ONS Unit will not operate properly.
Follow the steps listed below to install the ONS Unit.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Mount a main distribution frame (MDF) to the right of the KSU on the wooden
backboard. Then, mount the ONS Unit to the right of the MDF with the four
wood screws (refer to Figure 3-2).
Connect the MDF to the desired KSU station ports using a 25-pair cable and
two 50-pin ' D' Amp Connectors (refer to Figure 3-3).
Connect each of the four station ports from the MDF to one of the four modular
jacks on the left side of the ONS Unit. Use a DBU4 type cord (4-conductor
mod-to-mod cord) with an RJ14C connector to make the connection (refer to
Figure 3-4).
Each modular jack on the left-hand side of the ONS Unit corresponds to a jack
on the right-hand side. The modular jacks on the right-hand side connect to the
devices (single-line set, voice mail system or auto attendant). Connect the
modular jacks on the right-hand side of the ONS Unit to the devices using
DBU4 type cords with RJ14C connectors.
If the KSU power isn' t connected, plug in the KSU power cord.
Program the system to recognize the type of devices that are connected to the
ONS Unit. To program the type of device:
a. Connect a Panther II Display Set to Station 10
b. Dial *#015 to enter programming mode
Feature
Module IV & On Premise Station Unit
Page 14