Dialing Dtmf Tones - Mitel Panther II 820 System Manual

Panther II 820/1032/2064-297
NO.
1
2
3
4
5
6
7
8
9
10
TYPE OF CALL
External Incoming Forwarded Call
or
Internal DISA Forwarded Call
or
Note:
PP= Pause, Pause. The digit string for each type of call defaults to PP. You must change the
PP for each type of call to the digit string required by the voice mail system. It' s also
possible to change the duration of the Pause signal using system programming.
(Refer to Table 5-9)
Table S-5: Programming Digit Strings for the Type of Call
Step 4
Enter the DTMF string that is required by the voice mail system. The voice
mail system requires a specific DTMF string to recognize each type of call.
These DTMF strings should be provided in the documentation that is supplied
with the voice mail system. They can be a maximum of 5 digits in length.
The defaults are shown in Table 5-5.
You can program the following digits into the DTMF strings for the type of call:
0 to 9, *, #, A, B, C, D or Pause
However, for the Message Waiting data string (code #88), only A, B, C, or D can be
stored as the first digit. To enter an A, B, C, D tone or Pause, dial the digits/keys given
Table 5-6.
DTMFTONE
DIAL --
DTMF TONE DIAL --
A
Flash/Cancel key +3
D
Flash/Cancel key +#
B
Flash/Cancel key+6
PAUSE
Conference key
C
Flash/Cancel key+9
Table 5-6: Dialing DTMF Tones
Feature Module IV & On Premise Station Unit
Page 31