Configuring Ip Addresses For The Core Switch 2/64; Configuring The Control Processors; Areas To Be Configured For The Core Switch 2/64 - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Initial Configuration
8. Enter the ippaddrset command to verify the data you entered, and exit.
9. Repeat the steps to configure all SAN Switch 2/32 switches.
Example:
switch:admin> ipaddrset
Ethernet IP Address [10.77.77.77]: 10.64.119.7
Ethernet Subnetmask [10.77.77.76]: 255.255.240.0
Fibre Channel IP Address [0.0.0.0]:
Fibre Channel Subnetmask [0.0.0.0]:
Gateway IP Address [10.64.112.1]:
IP address being changed...
Committing configuration...Done.
switch:admin>

Configuring IP Addresses for the Core Switch 2/64

For the Core Switch 2/64, there are a number of Ethernet IP addresses and Fibre
Channel IP addresses to set. The procedures below describes how to configure
first the Control Processors, then the logical switches.
Table 1
2/64.
Table 1: Areas to be Configured for the Core Switch 2/64
Logical Switch 0
(Slots 1 - 4)
Ethernet IP Address
Ethernet Subnetmask
Fibre Channel IP
Address (Optional)
Fibre Channel
Subnetmask

Configuring the Control Processors:

1. Have the following information available:
16
describes the different areas that must be configured for a Core Switch
CP 0 (Slot 5)
Ethernet IP Address
Ethernet Subnetmask
Hostname
Gateway IP Address
— Ethernet IP Address
CP 1 (Slot 6)
Ethernet IP Address
Ethernet Subnetmask
Hostname
Gateway IP Address
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
Logical Switch 1
(Slots 7 - 10)
Ethernet IP Address
Ethernet Subnetmask
Fibre Channel IP
Address (Optional)
Fibre Channel
Subnetmask