HP StorageWorks MSA 2/8 - SAN Switch User Manual page 105

4. Reboot the standby CP card by pressing the yellow ejector buttons at top and
5. Press ESC within four seconds after the message Press escape
The following options are available:
6. Enter "3" at the prompt to enter the command shell.
7. Enter passwd command at the prompt.
Note:
boot interface.
8. Enter the Boot PROM password at the prompt, then re-enter when prompted.
9. Record this password for future use.
10. Enter the saveenv command to save the new password.
11. Reboot the standby CP card by entering the reset command.
12. Failover the active CP card by opening a telnet session to the Active CP card,
13. Connect the serial cable to the serial port on the new standby CP card
14. Repeat
15. Log in to the active CP card by serial or telnet and enter the haenable
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
bottom of the CP card, then pressing both ejector handles back towards the
switch to lock the card back into the slot. This causes the card to reset.
within 4 seconds... displays.
1) Start system.
2) Recovery password.
3) Enter command shell.
This command is specific to the Boot PROM password when entered from the
The password must be 8 alphanumeric characters (any additional characters
are not recorded).
logging in as Admin, and entering the hafailover command.
Traffic resumes flowing through the newly active CP card once it has
completed rebooting.
(previous active CP card).
step 3 through
a separate Boot PROM password).
command to restore high availability.
step 11 for the new standby CP card (each CP card has
Basic Security in FOS
105