Enabling A Port - HP StorageWorks MSA 2/8 - SAN Switch User Manual

portWwn of device(s) connected:
None
Distance: normal
portSpeed: N2Gbps
Interrupts: 1086 Link_failure: 0 Frjt: 0
Unknown: 0 Loss_of_sync: 0 Fbsy: 0
Lli: 0 Loss_of_sig: 0
Proc_rqrd: 1086 Protocol_err: 0
Timed_out: 0 Invalid_word: 0
Rx_flushed: 0 Invalid_crc: 0
Tx_unavail: 0 Delim_err: 0
Free_buffer: 0 Address_err: 0
Overrun: 0 Lr_in: 0
Suspended: 0 Lr_out: 0
Parity_err: 0 Ols_in: 0
2_parity_err: 0 Ols_out: 0
CMI_bus_err: 0
switch:admin>

Enabling a Port

To enable a port:
1. Log into the switch as the admin user.
2. Enter the portenable command at the command line, using the following
The following example is the portenable command.
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
syntax:
portenable [slotnumber]/portnumber
where slotnumber and portnumber are the slot and port number of the
port you want to enable. If the port is connected to another switch, the fabric
may reconfigure. If the port is connected to one or more devices, these devices
become available to the fabric.
Basic Switch Management
43