2. At the command line enter the msconfigure command. The command
3. At the select prompt enter 2 to add a member based on its Port/Node WWN.
4. At the prompt enter the WWN of the member you would like to add to the
5. At the prompt enter 1 to verify the WWN you entered was added to the ACL.
6. Once you have verified that the WWN was added correctly, enter 0 at the
7. At the "Update the FLASH?" prompt enter Y.
8. Press Enter to update the flash and end the session.
Example:
switch:admin> msconfigure
0
Done
1
Display the access list
2
Add member based on its Port/Node WWN
3
Delete member based on its Port/Node WWN
select : (0..3) [1] 2
Port/Node WWN (in hex): [00:00:00:00:00:00:00:00]
*WWN is successfully added to the MS ACL.
0
Done
1
Display the access list
2
Add member based on its Port/Node WWN
3
Delete member based on its Port/Node WWN
select : (0..3) [2] 1
<< Continued on next page.>>
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
becomes interactive.
ACL. Press the Return key, and the main menu is displayed.
prompt to end the session.
The SAN Management Application
129