Configuring The Control Processor Ip Addresses For The San Switch 2/32 - HP StorageWorks MSA 2/8 - SAN Switch User Manual

7. At the Gateway Address prompt, enter the IP address of the gateway system if
8. You are then prompted whether to make the IP address changes active now or
The following example shows how to configure the IP address for a SAN Switch
2/16 using the ipaddrset command.
Example:
switch:admin> ipaddrset
Ethernet IP Address [10.32.53.136]:
Ethernet Subnetmask [255.255.240.0]:
Fibre Channel IP Address [none]:
Fibre Channel Subnetmask [none]:
Gateway Address [10.32.48.1]:

Configuring the Control Processor IP Addresses for the SAN Switch 2/32

The SAN Switch 2/32 has one Control Processor (CP) for which the Ethernet IP
and host information must be configured.
1. Have the following information available for the new switch:
2. Log in to the switch as the admin user.
3. Enter the ipaddrset command at the command line. An interactive
4. Enter the Ethernet IP address and click Enter.
5. Enter the Ethernet Subnetmask and click Enter.
6. Enter the Hostname and click Enter.
7. Enter the Gateway IP Address and click Enter.
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
applicable. Press the Enter key to continue.
The configuration is then committed to the switch firmware.
at the next reboot. Enter y at the prompt to have the IP address changes take
effect immediately.
— Ethernet IP Address
— Ethernet Subnetmask
— Hostname
— Gateway IP Address
session is opened.
Initial Configuration
15