HP StorageWorks MSA 2/8 - SAN Switch User Manual page 50

Basic Switch Management
Fabric OS
Made on
Flash
BootProm
Usually the Made on and Flash dates are the same, since the switch starts running
flash firmware at power-on. However, in the time period between
firmwareDownload and the next reboot, the dates can differ.
3. Enter the firmwareShow command.
Example: SAN Switch 2/32
switch232:admin> firmwareshow
Local CP (Slot 5, CP0): Active
Primary partition: v4.0.2
Secondary Partition: v4.0.2
Remote CP is Non-redundant.
switch232:admin>
Example: Core Switch 2/64
switch264:admin> firmwareshow
Local CP (Slot 5, CP0): Active
Primary partition: v4.0.2
Secondary Partition: v4.0.2
Remote CP (Slot 6, CP1): Standby
Primary partition: v4.0.2
Secondary Partition: v4.0.2
switch264:admin>
50
Displays the version of switch Fabric OS
Displays the build date of firmware running in switch
Displays the build date of firmware stored in flash proms
Displays the version of the firmware stored in the boot PROM
Use this command to display the Fabric OS versions on primary and
secondary partitions on the local CP and on the remote CP. This command
identifies the status for each CP as Active or Standby, and will also identify
the slot number for each CP.
If there is only one CP available, the command displays the Fabric OS
versions for the primary and secondary partitions on that CP.
Fabric OS Procedures Version 3.1.x/4.1.x User Guide