Fabric Configuration Settings
It is important to have consistent system configuration settings since inconsistent
parameters among switches in the same fabric can cause fabric segmentation. To
troubleshoot a fabric segmentation issue, refer to
Configuration
The following parameters are included in the System Configuration Settings:
Displaying the Fabric Configuration Settings
To display and check system configuration settings, perform the following
procedure.
1. Log into the switch as the admin user.
2. Enter the configshow command at the command line. The system
switch:admin> configshow
RSCN.end-device.TransmissionMode:0
alpaList:1
boot.device:fei
boot.file:/usr/switch/firmware
boot.gateway.ipa:192.168.147.172
boot.ipa:192.168.147.172:ffffff00
boot.mac:10:00:00:60:69:80:04:22
boot.name:ter172
boot.server.ipa:
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
Settings" on page 55.
Fabric Parameters
Virtual Channel Settings
Zoning Operation Parameters
Rscn Transmission Mode
NS Pre-zoning Mode
Arbitrated Loop Parameters
System Services
Portlog Events Enable
configuration settings appear.
Basic Switch Management
"Restoring the System
53