HP StorageWorks MSA 2/8 - SAN Switch User Manual page 17

2. Log in to the switch as the admin user.
3. Enter the ipaddrset command at the command line. An interactive
4. Choose the CP that you want to configure. Enter the value that corresponds to
5. Enter the Ethernet IP Address when prompted. Click Enter.
6. Enter the Ethernet Subnetmask when prompted. Click Enter.
7. Enter the Hostname when prompted. Click Enter.
8. Enter the Gateway IP Address when prompted. Click Enter.
9. Enter the ippaddrshow command to verify the data you entered, and exit.
10. Enter the hafailover command to make the second CP active.
11. Repeat steps 1 through 9 to configure the second CP.
12. See
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
— Ethernet Subnetmask
— Hostname
— Gateway IP Address
session is opened.
that logical region:
— Enter 2 to configure CP 0 (slot 5).
— Enter 3 to configure CP 1 (slot 6).
"Configuring a Logical Switch IP Address for the Core Switch
configure the logical switch IP addresses.
Initial Configuration
2/64" to
17