Modifying Rtsp - Cisco SGE2000 - - Gigabit Switch Administration Manual

Configuring Spanning Tree
Defining Spanning Tree
STEP 2
STEP 3
STEP 1
STEP 2
Cisco Small Business SFE/SGE Managed Switches Administration Guide
•
Activate Protocol Migration — Click the
Migration Test. The test identifies the STP mode of the interface connected to
the selected interface.
Define the relevant fields.
Click Apply. The Rapid Spanning Tree Settings are defined, and the device is
updated.

Modifying RTSP

Click Bridging > Spanning Tree > RSTP. The
Click the Edit button. The
Edit Rapid Spanning Tree Page
Edit Rapid Spanning Tree Page
The
•
Interface — Specifies whether Rapid STP is enabled on a port or LAG.
•
Role — Indicates the port role assigned by the STP algorithm in order to
provide to STP paths. The possible field values are:
-
Root
— Provides the lowest cost path to forward packets to root switch.
-
Designated
switch is attached to the LAN.
-
Alternate
— Provides an alternate path to the root switch from the root
interface.
Edit Rapid Spanning Tree Page
contains the following fields:
— Indicates that the port or LAG via which the designated
Activate
button to run a Protocol
RSTP Page opens:
opens:
10
261