Cisco SGE2000 - - Gigabit Switch Administration Manual page 262

Configuring Spanning Tree
Defining Spanning Tree
STEP 1
Cisco Small Business SFE/SGE Managed Switches Administration Guide
Click Bridging > Spanning Tree > Interface Settings. The STP
Page
opens:
Interface Settings Page
Interface Settings Page
The STP
•
Copy From Entry Number — Indicates the port from which the STP interface
setting are copied.
•
To Entry Numbers — Indicates the port to which the STP interface setting are
copied.
•
Ports — Display the STP Interface settings of the specified stacking member's
ports.
•
LAGs — Display the STP Interface settings of device LAGs.
•
Port — Indicates the port or LAG on which STP is enabled.
•
STP — Indicates if STP is enabled on the port. The possible field values are:
-
Enable
— Indicates that STP is enabled on the port.
-
Disable
— Indicates that STP is disabled on the port.
•
Port Fast — Indicates if Fast Link is enabled on the port. If Fast Link mode is
enabled for a port, the Port State is automatically placed in the Forwarding
state when the port link is up. Fast Link optimizes the STP protocol
contains the following fields:
10
Interface Settings
253