Cisco SGE2000 - - Gigabit Switch Administration Manual page 202

Configuring IP Information
IP Addressing
STEP 2
Cisco Small Business SFE/SGE Managed Switches Administration Guide
-
Duplicate
— Indicates the IPv6 address is being used by an another host
on the network.
-
Preferred
— Indicates the DAD Status is set to active.
-
Tentative
— Indicates the system is in process of IPv6 address
duplication verification.
Click the Add button. The
Add IPv6 Address Interface Page
The
address to an interface.
Add IPv6 Address Interface Page
The Add IPv6 Address Interface Page contains the following fields:
•
Interface — Indicates the interface to which the address is added. The
possible field value is:
-
VLAN
— Indicates the VLAN for which the address is added.
•
IPv6 Type — Displays the IPv6 Type. The possible field values are:
-
Link-Local — Indicates the IPv6 address is link-local.
-
Global Unicast — Indicates the IPv6 address is global Unicast.
•
IPv6 Address — Indicates the IPv6 address assigned to the interface. Up to
five IP addresses can be set per interface, with the limitation that up to 128
addresses can be set per system. The address must be a valid IPv6 address,
specified in hexadecimal using 16-bit values between colons.
•
Prefix Length — Specifies the length of the IPv6 prefix. The range is 5 -128 (64
in the case EUI-64 parameter is used). The
the IPv6 Static IP Address is defined as an Global IPv6 Address.
Add IPv6 Address Interface Page opens:
provides information for adding an IPv6
Prefix field is applicable only when
7
193