Cisco SGE2000 - - Gigabit Switch Administration Manual page 167

Configuring Ports
STEP 2
STEP 3
STEP 4
Cisco Small Business SFE/SGE Managed Switches Administration Guide
•
To Entry Number(s) — Assigns the copied port configuration to the specified
table entry.
•
Unit Number — Indicates the stacking member for which the ports are defined.
•
Interface — Displays the port number.
•
Port Type — Displays the port type. The possible field values are:
-
1000M
— Copper (copper cable).
-
1000M
— ComboC (combo port with copper cable 3).
-
1000M — ComboF (combo port with optic fiber cable).
-
Fiber
— Indicates the port has a fiber optic port connection.
•
Port Status — Displays the port connection status. The possible field values
are:
-
Up
— Port is connected.
-
Down
— Port is disconnected.
•
Port Speed — Displays the current port speed.
•
Duplex Mode — Displays the port duplex mode. This field is configurable only
when auto negotiation is disabled, and the port speed is set to 10M or 100M.
This field cannot be configured on LAGs. The possible field values are:
-
Full
— Indicates that the interface supports transmission between the
device and the client in both directions simultaneously.
-
Half — Indicates that the interface supports transmission between the
device and the client in only one direction at a time.
•
LAG — Defines if the port is part of a Link Aggregation Group (LAG).
To copy the settings from one interface to another, enter the specific interface
numbers in the Copy From Entry Number and To Entry Number(s) fields.
Define the Unit number.
Click Apply. The Port Settings are defined, and the device is updated.
5
158