Cisco SGE2000 - - Gigabit Switch Administration Manual page 73

Configuring Device Security
Defining Access Methods
STEP 3
Cisco Small Business SFE/SGE Managed Switches Administration Guide
-
All
— Assigns all management methods to the rule.
-
Telnet
— Assigns Telnet access to the rule. If selected, users accessing
the device using Telnet meeting access profile criteria are permitted or
denied access to the device.
-
SNMP
— Assigns SNMP access to the rule. If selected, users accessing
the device using SNMP meeting access profile criteria are permitted or
denied access to the device.
access to the rule. If selected, users accessing the device using Telnet
meeting access profile criteria are permitted or denied access to the
device.
-
HTTP
— Assigns HTTP access to the rule. If selected, users accessing
the device using HTTP meeting access profile criteria are permitted or
denied access to the device.
-
Secure HTTP (HTTPS)
users accessing the device using HTTPS meeting access profile criteria
are permitted or denied access to the device.
•
Interface — Defines the interface on which the access profile is defined. The
possible field values are:
-
Port
— Specifies the port on which the access profile is defined.
-
LAG
— Specifies the LAG on which the access profile is defined.
-
VLAN — Specifies the VLAN on which the access profile is defined.
•
Source IP Address — Defines the interface source IP address to which the
access profile applies. The Source IP Address field is valid for a subnetwork.
•
Network Mask — Determines what subnet the source IP Address belongs to in
the network.
•
Prefix Length — Defines the number of bits that comprise the source IP
address prefix, or the network mask of the source IP address.
•
Action — Defines the action attached to the rule. The possible field values are:
-
Permit
— Permits access to the device.
-
Deny
— Denies access to the device. This is the default.
Define the relevant fields.
Secure Telnet (SSH)
— Assigns HTTPS access to the rule. If selected,
4
— Assigns SSH
64