Cisco SGE2000 - - Gigabit Switch Administration Manual page 331

Configuring SNMP
Defining Trap Management
STEP 2
Cisco Small Business SFE/SGE Managed Switches Administration Guide
•
Filter Name — Indicates if the SNMP filter for which the SNMP Notification filter
is defined.
•
Timeout — Indicates the amount of time (seconds) the device waits before re-
sending informs. The default is 15 seconds.
•
Retries — Indicates the amount of times the device re-sends an inform request.
The default is 3 seconds.
SNMPv3 Notification Recipient
The
•
Recipients IP — Indicates the IP address to whom the traps are sent.
•
Notification Type — Defines the notification sent. The possible field values are:
-
Trap
— Indicates traps are sent.
-
Inform
— Indicates informs are sent.
•
User Name — Displays the SNMP user names.
•
Security Level — Defines the means by which the packet is authenticated. The
possible field values are:
-
No Authentication
encrypted.
-
Authentication
-
Privacy
— Indicates the packet is both authenticated and encrypted.
•
UDP Port — Displays the UDP port used to send notifications. The default is
162.
•
Filter Name — Defines if the SNMP filter for which the SNMP Notification filter
is defined.
•
Timeout — Indicates the amount of time (seconds) the device waits before re-
sending informs. The default is 15 seconds.
•
Retries — Indicates the amount of times the device re-sends an inform request.
The default is 3 seconds.
Click the Add button. The
table area contains the following fields:
— Indicates the packet is neither authenticated nor
— Indicates the packet is authenticated.
Add SNMP Notification Recipient Page
12
opens.
322