Status Message - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

5.1.2.1 Status Message

The printer shows the status message only when:
o No error has occurred.
o The printer is initializing. Note only one status message is applied to
describe the current printer status.
See Table 5-4 and Table 5-5 which list the status messages and their
descriptions.
Table 5-4. Status Message List (1/2)
Ref Message
1 Self Test Testing and initializing the printer.
Reset All
2 While the printer is warming up, "Reset
All" appears if the printer is reset. During
normal operation "Reset" appears.
Reset
3 Resets the printer to default settings
during normal operation.
4 Reset to Save Appears when the print settings were
changed during printing. Perform one of
the following to clear the message.
1. Press the Continue button or the On
Line button to override the error and
continue printing. However, the
changes are not effective until the
ongoing job is completed.
2. Reset the printer or perform a warm
boot for a instant change of the setting,
but be aware that this erases any print
data in the printer's memory.
Warming Up
5 A "Ready" message that indicates the
printer is warming up.
Regulating
6 A "Ready" message that indicates the
Printer
printer engine is adjusting.
Chapter 5 TROUBLESHOOTING
Explanation Notes
By Warm
boot
Resetting
Table 5-5. Status Message List (2/2)
Ref Message
Standby Levelv
7 Another "Ready" message. Indicates that
the printer is in power-save standby state,
where v indicates the level.
1 = Standby Level 1, 2 = Standby Level 2
Ready
8 The printer is in an on line status.
Form Feed
9 Remaining print data is being printed and
the paper is exiting. Please wait a
moment.
10 Writing DIMM A Indicates the printer is writing data to the
ROM module inserted in DIMM slot A. Do
not remove the module or switch off
power until finished.*
11 Writing DIMM P Indicates the printer is writing data to the
ROM module inserted in DIMM slot P. Do
not remove the module or switch off
power until finished.*
Writing Data
12 Indicates the printer is writing data to the
DIMM
program ROM module.*
13 Writing Data RAM Indicates the printer is writing data to the
code table of the RAM.*
* Do not turn the printer nor remove the module.
Rev. B
Explanation Notes
5-3