Status Message - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

5.1.4.1 Status Message

The printer shows a status message only when:
The printer is free from any errors.
The printer is initializing.
Only one status message is applied to describe the current printer status. The
explanation for each status massage and solutions for errors are described
below.
NOTE: "Ready "message means that the printer performs printing as
soon as the "Ready" message is displayed during the
message shown.
ROM Check
Indicates that ROM check and format check are in process.
RAM Check
Indicates that the RAM's operation and memory checks are in process.
Self Test
Testing and initializing the printer.
Reset All
The printer is warmbooting, which is followed by reset operation with the
message "Reset" indicated.
Reset
Resets the printer.
Troubleshooting
Job Cancel
Job is being canceled.
Reset To Save
Appears when the print settings were changed during printing. Perform one
of the following to clear the message.
1. Press the On Line button to override the error and continue printing.
However, the changes are not effective until the ongoing job is
completed.
2. Reset the printer or perform a warm boot for a instant change of the
setting, but be aware that this erases any print data in the printer's
memory.
Writing ROM A
The printer is writing data to the form overlay ROM module. Do not remove
the module or switch off power until finished.
Writing ROM P
The printer is writing program data to the program ROM module. Do not
remove the module or switch off power until finished.
Form Feed
The "Form Feed" button has been pressed to forcibly print out the remaining
print data and eject the sheet.
Warming Up
A "Ready" message that indicates the printer is warming up.
Overview
Revision C
5-7