Deve. Spacer Selection - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.3.2 Deve. Spacer Selection

NOTE: "Deve. SPACER" is provided as ADJUSTMENT KIT
(#1046450).
NOTE: The generic term "Deve. Spacer"is used for DEVE. SPACER
0.5", "DEVE. SPACER 0.8", and "DEVE. SPACER 1.2".
NOTE: Steps included in this section describe how to select Deve.
Spacer, which must be performed after replacing the Developer
Assembly.
NOTE: During the whole operation, make sure there is no foreign object
inside the printer. If any foreign object gets inside the printer, it
may damage the drum.
1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
NOTE: In the following step, lift up the Developer Assembly so you can
easily insert the rib on the Deve. Spacer to space between the
stud in the Developer Assembly and Housing.
2. Rotate the corresponding Developer Assembly and stop it just
before the Toner Cartridge installation position, and then, holding up
the Developer Assembly in the direction indicated with the arrow,
attach the DEVE. SPACER 1.0 to the Developer Assembly. (If it is
already attached, you can use it.)
3. Rotate the Developer Assembly clockwise to send it to the top.
Chapter 3 Disassembly and Assembly/Adjustment
Deve. Spacer
Figure 3-150. Attaching the Deve Spacer 1.0
Revision B
3-123